Release Notes 3.9

2011-01-18

The files written with Release 3.9 can be read by older Versions of Cenon (down to Version 3.6), but the following new Features will be ignored:

• Project Settings (new in 3.9.0)

The following changes were made to the device files:

• Switch-Entries (#SW1, #SW2, #SW3, #SW4)
  (modified in 3.9.0)

  The Switch-Entries have been extended by two more parameters, allowing to set the title of the switch in the Control-Panel, and a flag to tell if the switch is safe.
  -> If the device entry is not updated, the old behaviour remains.

  The switch entries expect the following parameters:
  
  1. Command for switching ON
  2. Command for switching OFF
  3. Title of the switch, or "" to leave the default values.
  4. Flag: 1 = switch can be switched during output, 0 = switch is inactive during output.

  Example:
  Switch 1   #SW1 "Command On" "Command Off" "Spindle" 0
  Switch 2   #SW2 "Command On" "Command Off" "Music"   1

  In the Example it is not possible to turn off the Spindle while the machine is active, but it is possible to turn off the Music.

• Camera Support for Gauging (#COF)
  (added in 3.9.0)

  If the Camera-Gauging is needed, then you have to set the new Device-Entry "#COF" with the offset of the Camera. The offset is the distance of the camera relative to the tool. The tool being the origin.

  camera offset XY from tool (mm)   #COF 60.0 5.0